THP-IP216-AC 1 in 2 out Signal Isolator ( Universal input signal type )-Anhui Taihua instrument Co., LTD

THP-IP216-AC 1 in 2 out Signal Isolator ( Universal input signal type )

1 in 2 out, input 4-20mA, output 0-5V, AC220V power supply,

Input terminal interface can be connected to the current source, two-wire system, three-wire system transmitter;

Three-wire isolation, guide rail installation, high precision, high linearity, low temperature drift.

Type

THP
Number of Input Channels

1
Typical Input Signals

4-20mA,2-Wire 4-20mA
Number of Output Channels

2
Typical Output Signals

0-10V
Power Supply

AC/DC 85-265V
Additional Function

Online message

Product details Product parameter Overall dimension Wiring diagram

Product details: Product details

Product parameter: Product parameter

Input end

Input signal: 4-20mA

Distribution voltage: Open circuit voltage ≤25VDC Voltage at 20mA:>15V

Distribution working current: <25mA

Input impedance: ≤50Ω

Output end

Output signal: 0-10V

Output load resistance :RL≥10KΩ(output voltage signal);

Basic parameter

Power supply : AC/DC 85-265V

Rated power: ≤2W ( 10V output)

Basic accuracy : 0.1%F.S

Temperature drift : 0.005%F.S/℃ (-20℃~+55℃)

Response time : ≤10mS(0-90%)(TYP)

Insulation strength :1500V AC/1min (Between input, output and power supply)

Insulation resistance : >100MΩ (Input, output, power supply)

Operating temperature range : -20~+55℃

Electromagnetic compatibility: According to GB/T18268.1(IEC61326-1)

Applicable field equipment: Two-wire and three-wire transmitters, voltage source, current source signals

Use environment

(1) There must be no electromagnetic induction in the surrounding environment such as strong vibration, impact, large currents and sparks. The air should not contain media that corrodes chromium, nickel, and silver coatings, and should not contain flammable and explosive substances;

(2) Storage temperature: -40℃~+80℃;

(3) Relative humidity: 10%~90%RH;

Overall dimension: Overall dimension

Wiring diagram: Wiring diagram

Note:

1. When the thermocouple is input, the compensation wire should be directly connected to the input terminal, and the conductor of other materials should not be connected in the middle, otherwise the measurement error will be caused.

2, the bus power supply and RS485 output function is optional, if necessary, please specify and purchase the bus power supply module when ordering. The TS-TC5XX has no 485 output function.