THP-IP711 2 in 4 out Signal Isolator ( Universal input signal type )-Anhui Taihua instrument Co., LTD

THP-IP711 2 in 4 out Signal Isolator ( Universal input signal type )

2 in 4 out, input 4-20mA, output 4-20mA, DC24V power supply,

Input terminal interface can be connected to the current source, two-wire system, three-wire system transmitter;

Three-wire isolation, guide rail installation, high precision, high linearity, low temperature drift.

Type

THP
Number of Input Channels

2
Typical Input Signals

4-20mA,2-Wire 4-20mA
Number of Output Channels

4
Typical Output Signals

4-20mA
Power Supply

DC24V
Additional Function

Online message

Product details Product parameter Overall dimension Wiring diagram

Product details: Product details

Product parameter: Product parameter

Input end

Input signal: 4-20mA

Distribution voltage: ≥25VDC (Maximum drive current 30mA)

Distribution working current: <25mA

Input impedance: ≤50Ω

Output end

Output signal: 4-20mA

Output load resistance :RL≤500Ω(output current signal);

Basic parameter

Power supply : DC24V, ±10% voltage range :DC15~36V

Rated power : ≤2W

Basic accuracy : 0.1%F.S

Temperature drift : 0.005%F.S/℃ (-20℃~+55℃)

Response time : ≤10mS(0-90%)(TYP)

Insulation strength :1500V AC/1min (Between input, output and power supply)

Insulation resistance : >100MΩ (Input, output, power supply)

Operating temperature range : -20~+55℃

Electromagnetic compatibility: According to GB/T18268.1(IEC61326-1)

Applicable field equipment: Two-wire and three-wire transmitters, voltage source, current source signals

Use environment

(1) There must be no electromagnetic induction in the surrounding environment such as strong vibration, impact, large currents and sparks. The air should not contain media that corrodes chromium, nickel, and silver coatings, and should not contain flammable and explosive substances;

(2) Storage temperature: -40℃~+80℃;

(3) Relative humidity: 10%~90%RH;

Overall dimension: Overall dimension

Wiring diagram: Wiring diagram

Note:

1. When the thermocouple is input, the compensation wire should be directly connected to the input terminal, and the conductor of other materials should not be connected in the middle, otherwise the measurement error will be caused.

2, the bus power supply and RS485 output function is optional, if necessary, please specify and purchase the bus power supply module when ordering. The TS-TC5XX has no 485 output function.